Home › Power Source / Network › 1GD-FTV (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › 2019.02–2019.06
RM35X0E _57 Power Source / Network _078663 1GD-FTV BATTERY / CHARGING _0386530 BATTERY CURRENT SENSOR A

1GD-FTV BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery state sensor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative when not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lane control system Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative when not Performed Necessary Procedures Link
Power slide door system Fully close the slide door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the slide door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 67912A 2.REMOVE FRONT DOOR OUTSIDE SCUFF PLATE LH

a.
A456440

Insert a screwdriver into the gap, detach the claw and remove the 2 front door outside scuff plate LH.


Hide 67914B 3.REMOVE FRONT DOOR SCUFF PLATE LH

a.
A456441

Remove the 6 bolts.


b.

Detach the 2 claws and remove the front door scuff plate LH.


Hide 58408F 4.REMOVE BATTERY SERVICE HOLE COVER

a.
A437077

Remove the 5 bolts.


b.
A437078C01
0,0 0,0 false
V113147

Remove in this Direction


Hold the top part of the battery service hole cover sub-assembly LH and tilt it toward the outer side.


c.
A437079C01
0,0 0,0 false
V113147

Remove in this Direction


Lift it further up and remove the battery service hole cover sub-assembly LH.


Hide 28850C 5.REMOVE BATTERY STATE SENSOR ASSEMBLY

a.
A437517

Remove the nut to disconnect the engine wire from the battery state sensor assembly.


b.
A437518

Loosen the nut and disconnect the battery state sensor assembly from the battery.


c.
A437519

Disconnect the battery state sensor assembly connector from the battery state sensor assembly.