Home › Power Source / Network › 1GD-FTV (BATTERY / CHARGING) › CHARGING SYSTEM
RM35X0E _57 Power Source / Network _078663 1GD-FTV BATTERY / CHARGING _0383346 CHARGING SYSTEM C

1GD-FTV BATTERY / CHARGING  CHARGING SYSTEM  P16027B  Deterioration of Battery Low Fluid Level  


DESCRIPTION

The ECM determines the battery status according to the voltage of the BATT terminal while the engine is running (not cranking).

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory Note
P16027B Deterioration of Battery Low Fluid Level Battery capacity is low for 10 seconds or more when the engine is running (not cranking).
(1 trip detection logic)
·

Battery

·

Wire harness or connector


Charge warning light does not come on DTC stored SAE Code: P1602

WIRING DIAGRAM

A360357E03
0.844,2.708 1.917,2.906 1.073,0.198 10 false Battery 5.844,3.052 6.292,3.302 0.448,0.25 10 false ECM 1.271,1.146 2.344,1.365 1.073,0.219 10 false FL MAIN 3.635,1.156 4.417,1.365 0.781,0.208 10 false EFI-MAIN 5.302,0.865 6.083,1.073 0.781,0.208 10 false BATT 4.948,0.979 5.427,1.188 0.479,0.208 10 false N2 4.979,0.75 5.458,0.958 0.479,0.208 10 false 1 4.948,2.375 5.427,2.583 0.479,0.208 10 false A2 4.979,2.146 5.458,2.354 0.479,0.208 10 false 5 5.271,2.375 5.75,2.583 0.479,0.208 10 false E1

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


HINT:

If any DTCs other than P16027B are output, troubleshoot those DTCs first.


PROCEDURE

1.CHECK CHARGING SYSTEM

Result:
Result
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

NG

REPAIR OR REPLACE CHARGING SYSTEM

2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
a.

Disconnect the ECM connector.


b.
A444789C01
0.094,0.917 0.594,1.167 0.5,0.25 0.563,1.844 1.229,1.01 true 0.104,0.115 0.417,0.271 0.313,0.156 10 false *a 0.26,0.958 0.552,1.146 0.292,0.188 10 false N2 0.156,1.771 0.688,2 0.531,0.229 10 false BATT
*a Front view of wire harness connector
(to ECM)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
N2-1 (BATT) - Body ground Always 11 to 14 V



Result:
Result
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR