Home › Engine / Hybrid System › 1GD-FTV (COOLING) › COOLING SYSTEM › 2019.02–2020.05
RM35X0E _51 Engine / Hybrid System _079309 1GD-FTV COOLING _0386558 COOLING SYSTEM G

1GD-FTV COOLING  COOLING SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
A442817

Do not remove the reserve tank cap while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


PROCEDURE

Hide 1.INSPECT ENGINE COOLANT LEVEL IN RESERVOIR TANK

a.
A442818C01
2.698,1.823 2.125,1.333 true 2.865,0.854 2.115,0.854 2.115,0.854 2.115,1.208 true 2.896,0.75 3.208,0.906 0.313,0.156 10 false *a 2.74,1.792 3.052,1.948 0.313,0.156 10 false *b
*a F Line
*b L Line


Check that the engine coolant level is between the L line and F line when the engine is cold.

If the engine coolant level is low, check for leaks and add engine coolant to the F line.

NOTICE:
·

Do not substitute plain water for engine coolant.

·

The coolant levels in the compartments inside the radiator reserve tank assembly may differ, but this is not a malfunction.




Hide 2.INSPECT ENGINE COOLANT QUALITY

CAUTION:

Do not remove the reserve tank cap while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


a.
A442819

Remove the reserve tank cap.


b.

Check if there are any excessive deposits of rust or scale around the reserve tank cap and water filler hole. Also, the engine coolant should be free of oil.

If excessively dirty, replace the engine coolant.


c.

Install the reserve tank cap.


Hide 3.INSPECT FOR COOLANT LEAK

CAUTION:

Do not remove the reserve tank cap while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


a.

Remove the reserve tank cap.


b.
A442820C01
2.219,1.698 1.854,1.24 true 2.198,1.688 2.406,1.875 0.208,0.188 10 true *a
*a Radiator Cap Tester


Fill the radiator assembly with engine coolant, and then install a radiator cap tester.


c.

Warm up the engine.


d.

Pump the radiator cap tester to 118 kPa (1.2 kgf/cm2, 17 psi), and then check that the pressure does not drop.

·

If the pressure drops, check the hoses, radiator assembly and water pump assembly for leaks.

·

If there are no signs of external engine coolant leaks, check the heater core, cylinder block sub-assembly and cylinder head sub-assembly.



e.

Remove the radiator cap tester.


f.

Install the reserve tank cap.