Home › Power Source / Network › 1GD-FTV (BATTERY / CHARGING) › GENERATOR
RM35X0E _57 Power Source / Network _078663 1GD-FTV BATTERY / CHARGING _0386629 GENERATOR G

1GD-FTV BATTERY / CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27415 1.INSPECT GENERATOR PULLEY WITH CLUTCH

a.
A222451C05
0,0 0,0 false
V100135

Free
V100136

Lock


Hold the center of the generator pulley with clutch and check that the outer ring turns counterclockwise and does not turn clockwise.

If the result is not as specified, replace the generator pulley with clutch.


Hide 27370 2.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A128079C28
0.646,0.667 0.844,0.969 0.198,0.302 10 false *a
*a Length


Using a vernier caliper, measure the exposed brush length.

Standard exposed length:

9.5 to 11.5 mm (0.374 to 0.453 in.)


Minimum exposed length:

4.5 mm (0.177 in.)


If the exposed brush length is less than the minimum, replace the generator brush holder assembly.


Hide 27330 3.INSPECT GENERATOR ROTOR ASSEMBLY

a.
A079306

Check that the generator rotor bearing is not rough or worn and that it rotates smoothly.

If necessary, replace the generator rotor assembly.


b.
A153720C22
1.76,1.042 2.365,0.656 2.365,0.656 1.896,1.104 true 2.375,0.531 2.563,0.708 0.188,0.177 10 false *a
*a Slip Ring


Check the generator rotor assembly for an open circuit.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Generator Assembly Type Tester Connection Condition Specified Condition
for 100 A Slip ring - Slip ring 20°C (68°F) 1.8 to 2.2 Ω
for 130 A 1.55 to 1.95 Ω


If the result is not as specified, replace the generator rotor assembly.



c.
A153814C27
2.479,0.979 2.354,0.979 2.354,0.979 2.042,1.344 true 2.052,0.198 1.927,0.198 1.927,0.198 1.25,1.021 true 2.51,0.885 2.688,1.052 0.177,0.167 10 false *a 2.063,0.104 2.24,0.271 0.177,0.167 10 false *b
*a Slip Ring
*b Rotor Core


Check the generator rotor assembly for a short to ground.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Connection Specified Condition
Slip ring - Rotor core Always 1 MΩ or higher


If the result is not as specified, replace the generator rotor assembly.



d.

Check each slip ring.

i.

Check that the slip rings are not rough or scored.

If the slip rings are rough or scored, replace the generator rotor assembly.


ii.
A182587C14
0.542,0.583 0.698,0.76 0.156,0.177 10 false *a
*a Diameter


Using a vernier caliper, measure the slip ring diameter.

Standard diameter:

14.2 to 14.8 mm (0.559 to 0.583 in.)


Minimum diameter:

14.0 mm (0.551 in.)


If the diameter is less than the minimum, replace the generator rotor assembly.