DESCRIPTION
To check DTCs, connect the GTS or OBD scan tool to the Data Link Connector 3 (DLC3) of the vehicle. The scan tool displays DTCs, freeze frame data and a variety of engine data.
The DTCs and freeze frame data can be cleared with the scan tool.
FUNCTION OF WARNING INDICATOR
If the iMT system is not functioning properly, the driver is warned by the iMT warning light in the combination meter assembly.
| DTC | iMT Indicator
(iMT System ON) |
Detail |
|---|---|---|
| DTCs are stored | iMT warning light (yellow) illuminates | iMT system malfunction |
| DTCs are not stored | iMT indicator light (green) illuminates | iMT system standby condition |
FREEZE FRAME DATA
The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data stored at the time of a malfunction.
CHECK DATA LINK CONNECTOR 3 (DLC3)
Check the DLC3.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION
CHECK BATTERY VOLTAGE
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.