Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>REGISTRATION
When replacing the telephone transceiver assembly, make sure to replace it with a new one.
| *a | Component without harness connected
(Map Light Assembly (Manual (SOS) Switch)) |
Remove the map light assembly (manual (SOS) switch).
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL
Connect 4 dry-cell batteries (1.5 V each) in series.
Connect a positive (+) from the batteries lead to terminal 19 (RRID) and a negative (-) lead to terminal 21 (GND3) of the map light assembly (manual (SOS) switch) connector.
Check if the manual (SOS) switch illuminates.
Manual (SOS) switch illuminates.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the N74 telephone transceiver assembly connector.
Disconnect the a19 map light assembly (manual (SOS) switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N74-9 (SLED) - a19-19 (RRID) | Always | Below 1 Ω |
| N74-26 (SIG-) - a19-21 (GND3) | Always | Below 1 Ω |
| N74-9 (SLED) or a19-19 (RRID) - Body ground | Always | 10 kΩ or higher |
| N74-26 (SIG-) or a19-21 (GND3) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG