Do not remove the reserve tank cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
16471
1.CHECK RESERVE TANK CAP SUB-ASSEMBLY
Do not remove the radiator reserve tank cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
| *a | O-Ring |
| *b | Rubber Packing |
Measure the valve opening pressure.
If there are water stains or foreign matter on the O-ring, clean it with water and finger scouring.
Check that the O-ring is not deformed, cracked or swollen.
Apply engine coolant to the O-ring and rubber packing before using a radiator cap tester.
| *1 | Reserve Tank Cap Sub-assembly |
| *a | Radiator Cap Tester |
| *b | 30° or more |
When using the radiator cap tester, tilt it 30° or more.
Pump the radiator cap tester several times, and check the maximum pressure*.
1 pump per second
*: Even if the reserve tank cap sub-assembly cannot maintain the maximum pressure, it is not a defect.
| Item | Specified Condition |
|---|---|
| Standard value
(for brand-new cap) |
93 to 123 kPa (1.0 to 1.3 kgf/cm2, 13.5 to 18 psi) |
| Minimum standard value
(after using cap) |
79 kPa (0.8 kgf/cm2, 11.4 psi) |
If the maximum pressure is less than the minimum standard value, replace the reserve tank cap sub-assembly.