Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR
RM35X0E _59 Vehicle Exterior _079320 WIPER / WASHER _0385303 REAR WIPER MOTOR G

WIPER / WASHER  REAR WIPER MOTOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85110R 1.INSPECT REAR WIPER MOTOR ASSEMBLY

a.
B538448C01
0.76,1.063 1,1.375 true 1.156,1.813 1.375,1.813 false 0.594,0.927 0.906,1.125 0.313,0.198 10 false *a 1.417,1.729 1.729,1.927 0.313,0.198 10 false *b 0.688,1.542 1.094,1.833 0.406,0.292 10 false A
*a Matchmark
*b Stopped Position Marking


Operate the rear wiper motor assembly.


b.

Stop the rear wiper motor assembly operation.


c.

Check the automatic stop (park) position.

Standard Clearance:
Area Measurement
A 17 mm (0.669 in.)


HINT:

After the rear wiper motor assembly is stopped, check the automatic stop position after lifting the wiper blade 2 times.


OK:

Stop the rear wiper motor assembly so that it is between the matchmark and the stopped position marking as shown in the illustration.