The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
When replacing the battery, use a new battery of the same dimensions with a capacity of 70 Ah or more at a 20-hour rate.
67925D
2.REMOVE DOOR SCUFF PLATE COVER
|
Remove in this Direction |
Turn the 2 knobs right to release the lock and remove the door scuff plate cover.
58207E
3.REMOVE FRONT BATTERY SERVICE HOLE COVER SUB-ASSEMBLY LH
|
Remove in this Direction |
Place your hands as shown and pull toward the outer side to remove the front battery service hole cover sub-assembly LH.
4.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Loosen the nut, and disconnect the cable from the negative (-) battery terminal.
67912A
5.REMOVE OUTSIDE DOOR SCUFF PLATE
Insert a screwdriver into the gap, detach the claw and remove the 2 outside door scuff plates.
67914B
6.REMOVE FRONT DOOR SCUFF PLATE LH
Remove the 6 bolts.
Detach the 2 claws and remove the front door scuff plate LH.
58408F
7.REMOVE BATTERY SERVICE HOLE COVER SUB-ASSEMBLY LH
Remove the 5 bolts.
|
Remove in this Direction |
Hold the top part of the battery service hole cover sub-assembly LH and tilt it toward the outer side.
|
Remove in this Direction |
Lift it further up and remove the battery service hole cover sub-assembly LH.
28800
8.REMOVE BATTERY
Open the connector cover.
Loosen the nut and disconnect the cable from the positive (+) battery terminal.
Remove the 2 bolts and battery clamp.
|
Remove in this Direction |
Slide the battery to the outer side.
|
Remove in this Direction |
Lift the battery and remove it from the vehicle.