Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ACCELERATOR PEDAL
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0387391 ACCELERATOR PEDAL A

1GD-FTV ENGINE CONTROL  ACCELERATOR PEDAL  REMOVAL  


PROCEDURE

Hide 78110K 1.REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:

This accelerator pedal sensor assembly does not require lubrication.

Do not apply oil or other lubrication to the accelerator pedal sensor assembly.

If applied, the accelerator pedal sensor assembly must be replaced.


a.
A443207

for LHD:

i.

Disconnect the connector from the accelerator pedal sensor assembly.


ii.

Remove the 3 nuts and accelerator pedal sensor assembly.



b.
A443208

for RHD:

i.

Disconnect the connector from the accelerator pedal sensor assembly.


ii.

Remove the 3 nuts and accelerator pedal sensor assembly.