Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › AIR FUEL RATIO SENSOR
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0387398 AIR FUEL RATIO SENSOR A

1GD-FTV ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.


a.
A443564C01
0.906,0.531 1,0.531 1,0.531 1.24,1.042 true 1.656,1.917 1.854,2.094 0.198,0.177 10 true *a 0.573,0.427 0.906,0.604 0.333,0.177 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor.

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 37.7 N*m (384 kgf*cm, 28 ft.*lbf)




b.

Connect the connector and clamp.


Hide 51405A 3.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 52618 4.INSTALL LOWER FRONT BUMPER ABSORBER

Hide 51406A 5.INSTALL NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)