Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › NITROGEN OXIDES SENSOR › 2019.02–2019.06
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0387404 NITROGEN OXIDES SENSOR A

1GD-FTV ENGINE CONTROL  NITROGEN OXIDES SENSOR  REMOVAL  


PROCEDURE

Hide 89463D 1.REMOVE NITROGEN OXIDES SENSOR

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A440864

Disconnect the connector from the No. 4 exhaust gas temperature sensor.


b.
A440865

Detach the 2 clamps and disconnect the No. 4 exhaust gas temperature sensor from the sensor bracket.


c.
A443583

Disconnect the connector from the nitrogen oxides sensor.


d.

Remove the 2 bolts and sensor bracket.


e.
A443585N01
0.729,1.104 1.083,1.104 1.083,1.104 1.167,0.938 true 0.375,1.021 0.719,1.24 0.344,0.219 10 true SST

Using SST, remove the nitrogen oxides sensor.

SST
09224-00012  


f.
A443584

Remove the 2 nuts, detach the 2 clamps and then remove the nitrogen oxides sensor from the sensor bracket.