Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › NITROGEN OXIDES SENSOR › 2019.02–2019.06
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0387404 NITROGEN OXIDES SENSOR A

1GD-FTV ENGINE CONTROL  NITROGEN OXIDES SENSOR  INSTALLATION  


PROCEDURE

Hide 89463D 1.INSTALL NITROGEN OXIDES SENSOR

a.
A443584

Install the nitrogen oxides sensor to the sensor bracket with the 2 nuts, and attach the 2 clamps.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.
A443586C01
1.781,0.813 2.302,0.813 true 0.635,0.667 0.917,0.854 0.281,0.188 10 true *a 2.354,0.75 2.771,0.958 0.417,0.208 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the nitrogen oxides sensor.

SST
09224-00012  

Torque:
Specified tightening torque : 55 N*m (561 kgf*cm, 41 ft.*lbf)

NOTICE:

Replace with a new part if it is dropped or if it receives a strong impact.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 49.2 N*m (502 kgf*cm, 36 ft.*lbf)




c.
A443583

Install the sensor bracket to the vehicle body with the 2 bolts.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)


d.

Connect the connector to the nitrogen oxides sensor.


e.
A440865

Attach the 2 clamps and connect the No. 4 exhaust gas temperature sensor to the sensor bracket.


f.
A440864

Connect the connector to the No. 4 exhaust gas temperature sensor.