The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during steering vibration ECU removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learming the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
45100
1.REMOVE STEERING WHEEL ASSEMBLY
864A2
2.REMOVE STEERING VIBRATION ECU
|
Remove in this Direction |
Remove the 2 screws.
Move the steering vibration ECU until the connector can be disconnected as shown in the illustration.
Detach the connector and remove the steering vibration ECU.