Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 1GD-FTV(w/ Variable Flow Control Solenoid Valve))
RM35X0E _55 Steering _078944 POWER ASSIST SYSTEMS _0388797 VANE PUMP(for 1GD-FTV(w/ Variable Flow Control Solenoid Valve)) G

POWER ASSIST SYSTEMS  VANE PUMP(for 1GD-FTV(w/ Variable Flow Control Solenoid Valve))  INSPECTION  


PROCEDURE

Hide 1.INSPECT VANE PUMP ROTOR AND VANE PUMP PLATE

a.
C101978

Using a feeler gauge, measure the clearance between the side face of the vane pump rotor groove and the vane pump plates.

Maximum clearance:

0.025 mm (0.000984 in.)


If the clearance is more than the maximum, replace the vane pump plates, vane pump rotor and vane pump cam ring.

HINT:

Refer to the following table to select an appropriate combination of vane pump rotor, vane pump cam ring and vane pump plates.


Combination of Vane Pump Rotor, Vane Pump Cam Ring and Vane Pump Plates:
Vane Pump Cam Ring Part No. Vane Pump Rotor Part No. Vane Plate Part No.
44325-60080 44313-60010 44345-60060
44325-60090 44313-60020 44345-60070
44325-60100 44313-60030 44345-60080
44325-60110 44313-60040 44345-60090