Home › Steering › STEERING COLUMN › STEERING PAD SWITCH › 2019.02–2019.06
RM35X0E _55 Steering _079313 STEERING COLUMN _0388801 STEERING PAD SWITCH G

STEERING COLUMN  STEERING PAD SWITCH  INSPECTION  


PROCEDURE

Hide 84250A 1.INSPECT STEERING PAD SWITCH ASSEMBLY

a.

Inspect the steering pad switch assembly.

i.

Measure the resistance according to the value (s) in the table below.

C418498C01
5,0.646 5.458,0.979 0.458,0.333 4.031,1.198 4.625,1.271 true 5.365,2.906 5.948,2.906 true 5.208,2.719 5.594,2.313 true 5.448,2.708 6.083,2.479 true 5.188,3.125 5.885,3.51 true 5.313,3.458 5.76,3.875 true 5.156,3.563 5.469,4.135 true 4.854,3.646 5.063,4.396 true 1.292,2.917 1.875,2.917 true 2.031,2.042 2.208,2.854 true 1.302,2.427 2.01,2.917 true 2.365,2.042 2.438,2.74 true 1.49,3.427 2.042,3.115 true 1.75,3.906 2.063,3.458 true 2.021,4.125 2.25,3.552 true 2.344,4.219 2.521,3.625 true 2.469,3.083 3.042,2.792 true 4.281,2.688 4.865,3.031 true 3.906,0.99 4.375,0.646 true 3.021,1.448 3.5,1.167 true 3.167,0.667 3.479,1 true 3.729,1.188 4.208,1.76 true 3.146,1.667 3.604,1.188 true 3.76,1 4.052,0.406 true 3.375,0.385 3.594,0.99 true 1.677,2.167 2.052,2.698 true 3.865,1.219 4.604,1.563 true 5.448,3.042 6.521,3.26 true 0.156,0.083 0.469,0.24 0.313,0.156 10 false *a 1.531,1.99 1.844,2.146 0.313,0.156 10 false *b 1.323,3.375 1.635,3.531 0.313,0.156 10 false *c 1.927,1.823 2.24,1.979 0.313,0.156 10 false *d 1.094,2.833 1.406,2.99 0.313,0.156 10 false *e 1.177,2.281 1.49,2.438 0.313,0.156 10 false *f 2.271,1.781 2.604,2.01 0.333,0.229 10 false *g 3.083,2.698 3.396,2.854 0.313,0.156 10 false *h 2.177,4.271 2.646,4.51 0.469,0.24 10 false *i (*C) 1.917,4.104 2.146,4.333 0.229,0.229 10 false *j 1.604,3.917 1.917,4.073 0.313,0.156 10 false *k 5.813,3.875 6.125,4.031 0.313,0.156 10 false *l 5.448,4.188 5.76,4.344 0.313,0.156 10 false *m 5.01,4.469 5.323,4.625 0.313,0.156 10 false *n 5.615,2.156 6.083,2.396 0.469,0.24 10 false *o (*B) 5.938,3.469 6.427,3.74 0.49,0.271 10 false *p (*B) 6.01,2.813 6.469,3.021 0.458,0.208 10 false *r (*B) 3.865,2.563 4.323,2.771 0.458,0.208 10 false *s (*A) 2.583,0.51 3.229,0.75 0.646,0.24 10 false CCS (*B) 3.104,0.208 3.563,0.417 0.458,0.208 10 false AU1 4.438,0.5 4.896,0.708 0.458,0.208 10 false +DP2 4.063,0.219 4.521,0.427 0.458,0.208 10 false +DP 4.688,1.198 5.323,1.427 0.635,0.229 10 false ECC (*B) 4.135,1.823 4.594,2.031 0.458,0.208 10 false EAU 2.417,1.427 3.073,1.688 0.656,0.26 10 false DIST (*A) 2.927,1.688 3.385,1.896 0.458,0.208 10 false AU2 5.135,0.708 5.448,0.906 0.313,0.198 10 false z1 4.667,1.594 5.302,1.823 0.635,0.229 10 false ASL (*D) 6.146,2.354 6.656,2.615 0.51,0.26 10 false *q (*B) 6.552,3.188 7.063,3.448 0.51,0.26 10 false *t (*D)
*A w/ Lane Departure Alert System *B w/ Cruise Control System
*C w/ Voice Switch *D w/ Speed Limiter System
*a Component without harness connected
(Steering Pad Switch Assembly)
*b Up
*c Down *d Right
*e Left *f OK
*g Back *h On/off Hook
*i Voice *j Volume+
*k Volume- *l Seek+
*m Seek- *n MODE
*o +RES *p -SET
*q Cruise Control Main *r CANCEL
*s Lane Departure Alert *t Speed Limiter Switch


Standard Resistance:
Tester Connection Condition Specified Condition
z1-3 (AU1) - z1-10 (EAU) No switch pushed 95 to 105 kΩ
Seek+ switch pushed Below 2.5 Ω
Seek- switch pushed 313 to 345 Ω
Volume+ switch pushed 950 to 1050 Ω
Volume- switch pushed 2955 to 3265 Ω
z1-9 (AU2) - z1-10 (EAU) No switch pushed 95 to 105 kΩ
MODE switch pushed Below 2.5 Ω
On/off hook switch pushed 950 to 1050 Ω
Voice switch pushed (*C) 2955 to 3265 Ω
z1-5 (+DP2) - z1-10 (EAU) No switch pushed 95 to 105 kΩ
Left switch pushed Below 2.5 Ω
Up switch pushed 313 to 345 Ω
Down switch pushed 950 to 1050 Ω
Right switch pushed 2955 to 3265 Ω
z1-4 (+DP) - z1-10 (EAU) No switch pushed 95 to 105 kΩ
OK switch pushed Below 2.5 Ω
Back switch pushed 313 to 345 Ω
z1-8 (DIST) - z1-12 (ECC)*A No switch pushed 1 MΩ or higher
Distance control switch pushed Below 2.5 Ω
Lane departure alert switch pushed 228 to 252 Ω
z1-2 (CCS) - z1-12 (ECC)*B No switch pushed 1 MΩ or higher
Cruise control main switch pushed Below 2.5 Ω
CANCEL switch pushed 228 to 252 Ω
+RES switch pushed 599 to 661 Ω
-SET switch pushed 1463 to 1617 Ω
z1-11 (ASL) - z1-12 (ECC)*D No switch pushed 1 MΩ or higher
Speed limiter switch pushed Below 2.5 Ω


*A: w/ Lane Departure Alert System

*B: w/ Cruise Control System

*C: w/ Voice Switch

*D: w/ Speed Limiter System


HINT:

If the result is not as specified, replace the steering pad switch assembly.




b.

Check the illumination.

C412887C01
4.063,0.198 4.531,0.5 0.469,0.302 3.906,1.354 4.323,0.938 true 2.885,1.823 3.302,1.406 true 4.385,0.833 5.021,1.052 0.635,0.219 10 false ILL- 2.583,1.76 3.198,1.958 0.615,0.198 10 false IL+2 4.219,0.26 4.531,0.458 0.313,0.198 10 false z1 0.125,0.073 0.438,0.271 0.313,0.198 10 false *a
*a Component without harness connected
(Steering Pad Switch Assembly)
- -


i.

Connect a positive (+) lead from the auxiliary battery to terminal z1-1 (IL+2) and a negative (-) lead to terminal z1-6 (ILL-) of the steering pad switch assembly connector.


ii.

Check that the steering pad switch assembly illumination illuminates.

OK:

The steering pad switch assembly illumination illuminates.


HINT:

If the result is not as specified, replace the steering pad switch assembly.