When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
44310
1.SECURE VANE PUMP ASSEMBLY
Using a SST, secure the vane pump assembly.
2.REMOVE FLOW CONTROL VALVE
| *1 | Flow Control Valve Compression Spring |
| *2 | Flow Control Valve |
| *3 | O-ring |
| *4 | Pressure Port Union |
Using a 27 mm socket wrench, remove the pressure port union from the front housing.
Using a screwdriver, remove the O-ring from the pressure port union.
Remove the flow control valve from the front housing.
Remove the flow control valve compression spring from the front housing.
44337
3.REMOVE POWER STEERING SUCTION PORT UNION
Remove the bolt and suction port union from the vane pump assembly.
Remove the O-ring from the suction port union.
4.REMOVE REAR HOUSING
Remove the 4 bolts and rear housing from the front housing.
Remove the O-ring from the rear housing.
5.REMOVE VANE PUMP SHAFT SNAP RING
Using a screwdriver, remove the vane pump shaft snap ring from the shaft with pulley.
6.REMOVE VANE PUMP ROTOR
Remove the 10 vane pump plates from the vane pump rotor.
Be careful not to drop the vane pump plates.
Remove the vane pump rotor from the front housing.
7.REMOVE VANE PUMP CAM RING
Remove the vane pump cam ring.
8.REMOVE VANE PUMP SIDE PLATE
Remove the front vane pump side plate from the front housing.
Remove the O-ring from the front vane pump side plate.
Remove the O-ring from the front housing.