Home › General › MAINTENANCE › 1GD-FTV DRIVE BELT
RM35X0E _V1 General _078672 MAINTENANCE _0387904 1GD-FTV DRIVE BELT A

MAINTENANCE  1GD-FTV DRIVE BELT  REMOVAL  


PROCEDURE

Hide 51405A 1.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Viscous Heater)

a.
A443702C01
0,0 0,0 false
V100135

Bolt A
V100136

Bolt B


w/ No. 2 Engine Under Cover Sub-assembly:

i.

Remove the 16 clips, 6 bolts and No. 1 engine under cover sub-assembly.



b.
A443703C01
0,0 0,0 false
V100135

Bolt A
V100136

Bolt B


w/o No. 2 Engine Under Cover Sub-assembly:

i.

Remove the 14 clips, 6 bolts and No. 1 engine under cover sub-assembly.



Hide 88359 2.REMOVE VISCOUS HEATER V BELT (w/ Viscous Heater)

a.
A444783

Loosen the 2 bolts.


b.
A346688

Turn the bolt to loosen the viscous heater V belt and reduce the tension. Then remove the viscous heater V belt.


Hide 16361A 3.REMOVE FAN AND GENERATOR V BELT

a.
A369938C01
1.656,3.729 2.073,3.729 true 1,4.052 1,4.302 true 2.094,3.625 2.323,3.792 0.229,0.167 10 true *a 0.938,4.323 1.167,4.49 0.229,0.167 10 true *b
*a Service Hole
*b Pin


While turning the V-ribbed belt tensioner assembly clockwise, align the service holes of the V-ribbed belt tensioner assembly, and then insert a pin with a diameter of 5.0 mm (0.197 in.) into the service hole to fix the V-ribbed belt tensioner assembly in place.


b.

Remove the fan and generator V belt.