Home › General › MAINTENANCE › 1GD-FTV DRIVE BELT
RM35X0E _V1 General _078672 MAINTENANCE _0387904 1GD-FTV DRIVE BELT A

MAINTENANCE  1GD-FTV DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

a.

Set the fan and generator V belt onto each part.

HINT:

When installing the fan and generator V belt, attach the fan and generator V belt to the No. 1 idler pulley sub-assembly last.



b.

While turning the V-ribbed belt tensioner assembly clockwise, remove the pin.


c.

Check that the fan and generator V belt fits properly in the ribbed grooves.

NOTICE:

Make sure that the fan and generator V belt is set properly on each pulley.



Hide 88359 2.INSTALL VISCOUS HEATER V BELT (w/ Viscous Heater)

a.

Install the viscous heater V belt.


b.
A346688

Turn the bolt and adjust the tension of the viscous heater V belt.


c.
A444783

Tighten the 2 bolts.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


d.

Check the tension of the viscous heater V belt.


Hide 51405A 3.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Viscous Heater)

a.
A443702C01
0,0 0,0 false
V100135

Bolt A
V100136

Bolt B


w/ No. 2 Engine Under Cover Sub-assembly:

i.

Install the No. 1 engine under cover sub-assembly with the 16 clips and 6 bolts.

Torque:
for bolt A : 5.5 N*m (56 kgf*cm, 49 in.*lbf)
for bolt B : 7.5 N*m (76 kgf*cm, 66 in.*lbf)



b.
A443703C01
0,0 0,0 false
V100135

Bolt A
V100136

Bolt B


w/o No. 2 Engine Under Cover Sub-assembly:

i.

Install the No. 1 engine under cover sub-assembly with the 14 clips and 6 bolts.

Torque:
for bolt A : 5.5 N*m (56 kgf*cm, 49 in.*lbf)
for bolt B : 7.5 N*m (76 kgf*cm, 66 in.*lbf)