AUTOMATIC LEARNING PERFORMED WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
·
Learning completes when vehicle is driven
| Effect/Inoperative Function When Necessary Procedures are not Performed
|
Necessary Procedures
|
Link
|
|
|
| Stop and start system*
|
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes).
|
( )
|
| Lane control system
|
Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more.
|
( )
|
| Pre-collision system
|
·
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed
|
Necessary Procedures
|
Link
|
| Power slide door system
|
Fully close the slide door by hand.
- HINT:
-
Initialization is not necessary if the above procedures are performed while the slide door is closed.
|
( )
|
| Air conditioning system
|
After the ignition switch is turned to ON, the servo motor standard position is recognized.
|
-
|