The ECM and brake system control module send and receive signals via CAN communication.
If a communication error occurs between the ECM and brake system control module, the ECM stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| U012987 | Lost Communication With Brake System Control Module Missing Message | There is no communication between the ECM and brake system control module (1 trip detection logic). | ·
ECM ·
Brake system control module ·
CAN communication system |
Class C | DTC stored | SAE Code: U0129 |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| U012987 | Engine switch on (IG) for 5 seconds or more |
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine and Transmission / Trouble Codes.
Read the DTCs using the GTS.
| Result | Proceed to |
|---|---|
| DTC U012987 is not output | A |
| DTC U012987 is output | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING