This DTC is stored when the telephone transceiver assembly detects an open or short circuit in the manual (SOS) switch.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15C5 | Emergency Switch Error (Open or Short) | Open or short circuit in the manual (SOS) switch is detected. | ·
Telephone transceiver assembly ·
Map light assembly (manual (SOS) switch) ·
Harness or connector |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>REGISTRATION
When replacing the telephone transceiver assembly make sure to replace it with a new one.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and wait for 20 seconds.
Turn the GTS on.
Check for DTCs and check that no DTCs are output.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>DTC CHECK / CLEAR
No DTCs are output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (High roof) | B |
| NG (Standard roof) | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
Remove the map light assembly (manual (SOS) switch).
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL
| *a | Component without harness connected
(Map Light Assembly (Manual (SOS) Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 22 (SIG1) - 21 (GND3) | Manual (SOS) switch not pressed | 392 to 432 Ω |
| 22 (SIG1) - 21 (GND3) | Manual (SOS) switch pressed | 78 to 86 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the N74 telephone transceiver assembly connector.
Disconnect the a19 map light assembly (manual (SOS) switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N74-27 (SIG1) - a19-22 (SIG1) | Always | Below 1 Ω |
| N74-26 (SIG-) - a19-21 (GND3) | Always | Below 1 Ω |
| N74-27 (SIG1) or a19-22 (SIG1) - Body ground | Always | 10 kΩ or higher |
| N74-26 (SIG-) or a19-21 (GND3) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the telephone transceiver assembly with a new one.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER (for LHD)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Remove the map light assembly (manual (SOS) switch).
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT (for Wagon)>REMOVAL
| *a | Component without harness connected
(Map Light Assembly (Manual (SOS) Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 17 (SIG1) - 12 (GND3) | Manual (SOS) switch not pressed | 392 to 432 Ω |
| 17 (SIG1) - 12 (GND3) | Manual (SOS) switch pressed | 78 to 86 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the N74 telephone transceiver assembly connector.
Disconnect the a22 map light assembly (manual (SOS) switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N74-27 (SIG1) - a22-17 (SIG1) | Always | Below 1 Ω |
| N74-26 (SIG-) - a22-12 (GND3) | Always | Below 1 Ω |
| N74-27 (SIG1) or a22-17 (SIG1) - Body ground | Always | 10 kΩ or higher |
| N74-26 (SIG-) or a22-12 (GND3) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the telephone transceiver assembly with a new one.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER (for LHD)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT