The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the rear height control sensor sub-assembly LH removal/installation are shown below.
58399D
1.REMOVE NO. 2 FLOOR UNDER COVER
Remove the 6 bolts.
Using a screwdriver, loosen the 2 clips, and remove the No. 2 floor under cover.
89408C
2.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
If the rear height control sensor sub-assembly LH has been dropped, replace it with a new one.
|
Connector |
|
Bolt |
|
Nut |
Disconnect the connector.
Remove the 2 bolts and nut.
Do not reuse the nut.
Detach the guide and remove the rear height control sensor sub-assembly LH.