The illuminated entry system controls the push start switch illumination.
Check that the "Engine Start Indicator" customization setting is set to "ON".
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>CUSTOMIZE PARAMETERS
Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.
Perform the Active Test according to the display on the GTS.
Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Power/Engine SW Light | Push start switch illumination | OFF or ON | - |
| Tester Display |
|---|
| Power/Engine SW Light |
Push start switch illumination comes on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the push start switch.
for 7GR-FKS:
Click hereEngine / Hybrid System>7GR-FKS (STARTING)>ENGINE SWITCH>REMOVAL
for 1GD-FTV:
Click hereEngine / Hybrid System>1GD-FTV (STARTING)>ENGINE SWITCH>REMOVAL
Inspect the push start switch.
for 7GR-FKS:
Click hereEngine / Hybrid System>7GR-FKS (STARTING)>ENGINE SWITCH>INSPECTION
for 1GD-FTV:
Click hereEngine / Hybrid System>1GD-FTV (STARTING)>ENGINE SWITCH>INSPECTION
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 7GR-FKS) | B |
| NG (for 1GD-FTV) | C |
A
B
C
Disconnect the N162 push start switch connector.
Disconnect the N156 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N162-9 (SWIL) - N156-10 (SWIL) | Always | Below 1 Ω |
| N162-6 (AGND) - N156-11 (AGND) | Always | Below 1 Ω |
| N162-9 (SWIL) or N156-10 (SWIL) - Body ground | Always | 10 kΩ or higher |
| N162-6 (AGND) or N156-11 (AGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG