Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER › from 2019.06
RM35X0E _58 Vehicle Interior _078337 METER / GAUGE / DISPLAY _0380006 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 55631A 1.REMOVE NO. 1 INSTRUMENT PANEL UNDER TRAY STOPPER

Hide 55011A 2.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 55044C 3.REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 55404E 4.REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 83100 5.REMOVE COMBINATION METER ASSEMBLY

a.
E415116

Remove the 2 screws.


b.
E415117C01
0,0 0,0 false
V113147

Remove in this Direction


Pull towards the rear of the vehicle to detach the clip and guide and remove the combination meter assembly.


c.
E415118C01
0.083,0.083 0.458,0.323 0.375,0.24 12 false *A 0.083,2.344 0.458,2.583 0.375,0.24 12 false *B
*A for TFT Display Type
*B for Segment Display Type


Detach the clamp and disconnect the 2 connectors.