Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81340
1.REMOVE VANITY LIGHT ASSEMBLY
|
Protective Tape |
|
Remove in this Direction |
Using a thin-bladed screwdriver, detach the claw and guide.
Tape the thin-bladed screwdriver tip before use.
|
Remove in this Direction |
Detach the claw and remove the vanity light assembly as shown in the illustration.
81340B
2.REMOVE VANITY LIGHT BULB
|
Remove in this Direction |
Remove the vanity light bulb from the vanity light bulb holder as shown in the illustration.