Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81340
1.DISCONNECT VANITY LIGHT ASSEMBLY
|
Protective Tape |
|
Remove in this Direction |
Using a thin-bladed screwdriver, detach the claw and guide and disconnect the vanity light assembly.
Tape the thin-bladed screwdriver tip before use.
81340B
2.REMOVE VANITY LIGHT BULB
|
Remove in this Direction |
Remove the vanity light bulb from the vanity light bulb holder.
81340B
3.INSTALL VANITY LIGHT BULB
|
Install in this Direction |
Install the vanity light bulb to the vanity light bulb holder.
81340
4.CONNECT VANITY LIGHT ASSEMBLY
|
Install in this Direction |
Attach the guide and claw to connect the vanity light assembly.