1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
2.REMOVE ROOF HEADLINING ASSEMBLY
for Wagon:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Wagon)>REMOVAL
for Semi-trim:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Semi-trim)>REMOVAL
for Full-trim:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Full-trim)>REMOVAL
88539K
3.REMOVE DRAIN COOLER HOSE
for Standard Roof:
Disconnect each drain cooler hose.
for High Roof:
Disconnect each drain cooler hose.
88539W
4.REMOVE NO. 2 DRAIN COOLER HOSE
for Standard Roof:
Disconnect each No. 2 cooler unit drain hose.
for High Roof:
Disconnect each No. 2 cooler unit drain hose.
87030A
5.REMOVE REAR COOLING UNIT ASSEMBLY
for Standard Roof:
Remove the cooling unit parts.
for High Roof:
Remove the cooling unit parts.
| *1 | Cooler Refrigerant Liquid Pipe D |
| *2 | Cooler Refrigerant Suction Pipe D |
for Standard Roof:
Remove the 2 bolts.
Disconnect the cooler refrigerant liquid pipe D and cooler refrigerant suction pipe D.
| *1 | Cooler Refrigerant Liquid Pipe D |
| *2 | Cooler Refrigerant Suction Pipe D |
for High Roof:
Using a double wrench, remove the union nuts and disconnect the cooler refrigerant liquid pipe D and cooler refrigerant suction pipe D.
Remove the O-ring from the cooler refrigerant liquid pipe D and cooler refrigerant suction pipe D.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
for Standard Roof:
Disconnect each connector.
Detach each clamp and remove the vehicle wire harness.
While supporting the rear cooling unit assembly to prevent it from falling, remove the 6 bolts. Then, while moving the rear cooling unit assembly in the direction indicated by the arrow shown in the illustration, remove the front mounting position from the vehicle roof reinforcement and remove the rear cooling unit assembly.
|
Remove in this Direction | - | - |
for High Roof:
Disconnect each connector.
Detach each clamp and remove the vehicle wire harness.
While supporting the rear cooling unit assembly to prevent it from falling, remove the 6 bolts. Then, while moving the rear cooling unit assembly in the direction indicated by the arrow shown in the illustration, remove the front mounting position from the vehicle roof reinforcement and remove the rear cooling unit assembly.
|
Remove in this Direction | - | - |