The main body ECU (multiplex network body ECU) communicates with the rain sensor via LIN communication. If a malfunction occurs in the LIN communication line and a communication error occurs, this DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from |
|---|---|---|---|---|---|
| B1373 | Lost Communication with Wiper System LIN BUS | DTC Detection Condition:
Ignition switch ON (IG+ voltage 9.5 V or higher) Malfunction Status:
Wire-type LIN communication error detected Malfunction Duration:
7 seconds or more |
·
Rain sensor ·
Harness or connector ·
Main body ECU (multiplex network body ECU) |
○ | Main Body |
If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.
Clear the DTCs.
Click hereVehicle Exterior>WIPER / WASHER>WIPER AND WASHER SYSTEM>DTC CHECK / CLEAR
Turn the ignition switch to ON and wait for at least 10 seconds.
Check for DTCs.
Click hereVehicle Exterior>WIPER / WASHER>WIPER AND WASHER SYSTEM>DTC CHECK / CLEAR
DTC B1373 is not output
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Disconnect the a8 rain sensor connector.
Clear the DTCs.
Click hereVehicle Exterior>WIPER / WASHER>WIPER AND WASHER SYSTEM>DTC CHECK / CLEAR
Turn the ignition switch to ON and wait for at least 10 seconds.
Check for DTCs.
Click hereVehicle Exterior>WIPER / WASHER>WIPER AND WASHER SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC B1373 is not output, but DTC B1279 is output | A |
| DTC B1373 is output | B |
A
B
Disconnect the N18 main body ECU (multiplex network body ECU) connector.
Disconnect the a8 rain sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N18-3 (LIN3) - a8-3 (MPX) | Always | Below 1 Ω |
| N18-3 (LIN3) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
for LHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL
for RHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL
NG