This DTC is output when the slide door motor unit LH (slide door ECU LH) detects a malfunction in the power slide door sensor assembly LH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B222D | Rear Power Slide Door LH Touch Sensor Circuit | Malfunction detected in power slide door sensor assembly LH | ·
Power slide door sensor assembly LH ·
Slide door motor unit LH (slide door ECU LH) ·
Harness or connector |
If the replacement, removal and installation of the slide door motor unit or disconnection of the connectors of the slide door motor unit has been performed, initialize the power slide door system.
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR SYSTEM>INITIALIZATION
Clear the DTC.
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR SYSTEM>DTC CHECK / CLEAR
Check for DTC.
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR SYSTEM>DTC CHECK / CLEAR
DTC B222D is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Read the Data List according to the display on the GTS.
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Normal Condition | Reference Value | Diagnostic Note |
|---|---|---|---|---|
| PSD Touch Sensor | Power slide door sensor assembly LH signal | OFF, ON or Open | OFF: Power slide door sensor assembly LH not pressed
ON: Power slide door sensor assembly LH pressed Open: Power slide door sensor assembly LH open |
- |
| Tester Display |
|---|
| PSD Touch Sensor |
On the GTS screen, ON or OFF is displayed accordingly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the power slide door sensor assembly LH.
except Wagon:
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR TOUCH SENSOR (except Wagon)>REMOVAL
for Wagon:
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR TOUCH SENSOR (for Wagon)>REMOVAL
Inspect the power slide door sensor assembly LH.
except Wagon:
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR TOUCH SENSOR (except Wagon)>INSPECTION
for Wagon:
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR TOUCH SENSOR (for Wagon)>INSPECTION
| Result | Proceed to |
|---|---|
| OK | A |
| NG (except Wagon) | B |
| NG (for Wagon) | C |
A
B
C
Disconnect the T4 slide door motor unit LH (slide door ECU LH) connector.
Disconnect the U6 power slide door sensor assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T4-4 (OSG) - U6-2 (OSG) | Always | Below 1 Ω |
| T4-1 (OS) - U6-1 (OS) | Always | Below 1 Ω |
| T4-4 (OSG) or U6-2 (OSG) - Body ground | Always | 10 kΩ or higher |
| T4-1 (OS) or U6-1 (OS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG