Use these procedures to troubleshoot the CXPI communication system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, check the CXPI communication function to ensure that there are no malfunctions in the communication system.
Click herePower Source / Network>NETWORKING>CXPI COMMUNICATION SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| No DTCs output |
| DTCs output |
No DTCs output
DTCs output
Data List / Active Test
Click herePower Source / Network>NETWORKING>CXPI COMMUNICATION SYSTEM>DATA LIST / ACTIVE TEST
Terminals of ECU
Click herePower Source / Network>NETWORKING>CXPI COMMUNICATION SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT