The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during the radiator grille sub-assembly removal/installation are shown below.
When the radiator grille sub-assembly is damaged or deformed due to an accident or contact with other objects, etc., or the radiator grille installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT
53106B
1.REMOVE RADIATOR COVER SUB-ASSEMBLY
Remove the 9 clips.
|
Remove in this Direction |
Detach the guide and remove the radiator cover sub-assembly as shown in the illustration.
52128B
2.REMOVE FRONT BUMPER HOLE COVER LH
|
Remove in this Direction |
Detach the claw as shown in the illustration.
|
Remove in this Direction |
|
Fall Prevention Hook |
Disconnect the fall prevention hook and remove the front bumper hole cover LH as shown in the illustration.
52127D
3.REMOVE FRONT BUMPER HOLE COVER RH
Use the same procedure described for the LH side.
53101
4.REMOVE RADIATOR GRILLE SUB-ASSEMBLY
Remove the 4 bolts.
Apply protective tape around the radiator grille sub-assembly.
|
Protective Tape | - | - |
| *A | w/ Pre-collision System |
| *B | w/ Panoramic View Monitor System |
w/ Pre-collision System:
Disconnect the connector.
w/ Panoramic View Monitor System:
Disconnect the connector.
|
Place Hand Here |
|
Remove in this Direction |
|
Order of Removal |
Detach the 5 clips and claw as shown in the illustration.
|
Place Hand Here |
|
Remove in this Direction |
|
Order of Removal |
Detach the 5 clips and claw as shown in the illustration.
Detach the claw and remove the radiator grille sub-assembly as shown in the illustration.
|
Place Hand Here |
|
Remove in this Direction |