Avoid any impact to the blind spot monitor sensor.
Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.
The blind spot monitor beam axis inspection is performed to confirm whether the sensor is transmitting radio waves.
The blind spot monitor beam axis confirmation is performed to confirm whether the sensor's beam axis is correct, and perform adjustment of the beam axis by using a reflector.
The blind spot monitor sensor installation condition inspection is performed to confirm whether the sensor is placed vertically to the ground (+/-2.2°) by using a jig, and that the sensor is 46 to 54° from the line parallel to the vehicle center line.
88172
1.INSTALL BLIND SPOT MONITOR SENSOR LH
| *A | except Wagon |
| *B | for Wagon |
|
Nut |
|
Connector |
Connect the connector.
Install the blind spot monitor sensor LH with 3 nuts.
Do not drop the blind spot monitor sensor LH. If it is dropped, replace it with a new one.
88162
2.INSTALL BLIND SPOT MONITOR SENSOR RH
Use the same procedure described for the LH side.
88173
3.INSTALL BLIND SPOT MONITOR COVER LH (w/ Blind Spot Monitor Cover)
Install the blind spot monitor cover LH with 2 nuts.
88163
4.INSTALL BLIND SPOT MONITOR COVER RH (w/ Blind Spot Monitor Cover)
Use the same procedure described for the LH side.
5.PERFORM BLIND SPOT MONITOR SENSOR INSTALLATION CONDITION INSPECTION
52166A
6.INSTALL REAR BUMPER UPPER COVER LH
except Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (except Wagon)>INSTALLATION
for Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (for Wagon)>INSTALLATION
52165A
7.INSTALL REAR BUMPER UPPER COVER RH
Use the same procedure described for the LH side.
52162G
8.INSTALL REAR BUMPER NO. 1 PLATE (for Wagon)
9.INSTALL REAR BUMPER ASSEMBLY
except Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (except Wagon)>INSTALLATION
for Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (for Wagon)>INSTALLATION
52162B
10.INSTALL REAR BUMPER NO. 1 PLATE
except Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (except Wagon)>INSTALLATION
for Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (for Wagon)>INSTALLATION
11. PERFORM DIAGNOSTIC SYSTEM CHECK
12.PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SENSOR>ADJUSTMENT