The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear lateral control rod assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
89408C
1.DISCONNECT HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR LH
Remove the nut and disconnect the rear height control sensor sub-assembly from the rear lateral control rod assembly.
48740
2.REMOVE REAR LATERAL CONTROL ROD ASSEMBLY
Remove the nut, washer, 2 bolts and rear lateral control rod assembly from the rear axle housing assembly and vehicle body.
When removing the nuts, keep the bolts from rotating.