Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › PARTICULATE MATTER SENSOR › from 2019.06
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0397338 PARTICULATE MATTER SENSOR A

1GD-FTV ENGINE CONTROL  PARTICULATE MATTER SENSOR  INSTALLATION  


PROCEDURE

Hide 894A0 1.INSTALL PARTICULATE MATTER SENSOR

a.
A448431

Install the particulate matter sensor to the sensor bracket with the 2 nuts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.
A448432C01
1.083,1.01 1.635,1.01 true 2.51,0.594 2.792,0.792 0.281,0.198 10 true *a 0.729,0.917 1.083,1.146 0.354,0.229 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the particulate matter sensor.

SST
09224-00030  

Torque:
Specified tightening torque : 50 N*m (510 kgf*cm, 37 ft.*lbf)

NOTICE:

Replace with a new part if it is dropped or if it receives a strong impact.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 43.2 N*m (441 kgf*cm, 32 ft.*lbf)




c.
A448429

Install the sensor bracket to the vehicle body with the 2 bolts.

Torque:
30 N*m (306 kgf*cm, 22 ft.*lbf)


d.
A448428

Attach the 3 clamps.


e.
A448427

Connect the connector to the particulate matter sensor.