The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the vacuum pump assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
17190
2.REMOVE INTAKE AIR SURGE TANK ASSEMBLY
3.DISCONNECT VACUUM HOSE ASSEMBLY
Slide the clip and disconnect the vacuum hose assembly from the vacuum pump assembly.
87249B
4.SEPARATE OUTLET HEATER WATER PIPE B
Slide the clip and disconnect the outlet heater water hose B from the outlet heater water pipe B.
Remove the bolt and separate the outlet heater water pipe B from the engine assembly.
29300
5.REMOVE VACUUM PUMP ASSEMBLY
Remove the 3 bolts and vacuum pump assembly from the engine assembly.
| *1 | No. 2 O-ring |
| *2 | No. 3 O-ring |
Remove the No. 2 O-ring and No. 3 O-ring from the vacuum pump assembly.