89463C
1.DISCONNECT NO. 1 NITROGEN OXIDES SENSOR (w/ Exhaust Gas Temperature Sensor for EGR)
Disconnect the connector from the No. 1 nitrogen oxides sensor.
Remove the 2 bolt.
Detach the 2 clamps and disconnect the No. 1 nitrogen oxides sensor.
25051
2.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (w/ Exhaust Gas Temperature Sensor for EGR)
89463C
3.REMOVE NO. 1 NITROGEN OXIDES SENSOR (w/ Exhaust Gas Temperature Sensor for EGR)
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Using SST, remove the No. 1 nitrogen oxides sensor.
Remove the 2 nuts, detach the clamp (cable tie), and then remove the No. 1 nitrogen oxides sensor from the exhaust sensor clamp bracket.
89463D
4.REMOVE NO. 2 NITROGEN OXIDES SENSOR
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Disconnect the connector from the No. 4 exhaust gas temperature sensor.
Detach the 2 clamps and disconnect the No. 4 exhaust gas temperature sensor from the sensor bracket.
Disconnect the connector from the No. 2 nitrogen oxides sensor.
Remove the 2 bolts and sensor bracket.
Using SST, remove the No. 2 nitrogen oxides sensor.
Remove the 2 nuts, detach the 2 clamps and then remove the No. 2 nitrogen oxides sensor from the sensor bracket.