The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during the ambient temperature sensor removal/installation are shown below.
When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT
1.REMOVE FRONT BUMPER ASSEMBLY
except Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (except Wagon)>REMOVAL
for Wagon:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Wagon)>REMOVAL
88790B
2.REMOVE THERMISTOR ASSEMBLY (AMBIENT TEMPERATURE SENSOR)
except Wagon:
Detach the clamp.
Disconnect the connector and remove the thermistor assembly (ambient temperature sensor).
for Wagon:
Detach the clamp.
Disconnect the connector and remove the thermistor assembly (ambient temperature sensor).