Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ACCELERATOR PEDAL › 2019.06–2020.05
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0387391 ACCELERATOR PEDAL G

1GD-FTV ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Data List / Accelerator Sensor No.1 Voltage % and Accelerator Sensor No.2 Voltage %.

Powertrain > Engine > Data List
Tester Display
Accelerator Position Sensor No.1 Voltage %
Accelerator Position Sensor No.2 Voltage %
50003 372 256,257

e.

Operate the accelerator pedal sensor assembly and check that the "Accelerator Sensor No.1 Voltage %" and "Accelerator Sensor No.2 Voltage %" values are within the specification.

Standard Voltage (Accelerator Sensor No.1 Voltage %):
Accelerator Pedal Condition Specified Condition
Released 10 to 22%
Depressed 52 to 90%


Standard Voltage (Accelerator Sensor No.2 Voltage %):
Accelerator Pedal Condition Specified Condition
Released 24 to 40%
Depressed 68 to 99%


If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.