Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
71848R
1.REMOVE FRONT SEAT NO. 1 ADJUSTER COVER CAP LH
|
Remove in this Direction |
Remove the front seat No. 1 adjuster cover cap LH as shown in the illustration.
71848S
2.REMOVE FRONT SEAT NO. 2 ADJUSTER COVER CAP LH
|
Remove in this Direction |
Remove the front seat No. 2 adjuster cover cap LH as shown in the illustration.
71139P
3.REMOVE FRONT SEAT OUTER LEG COVER LH
Remove the clip.
Remove the screw.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the position and pull in the removal direction shown in the illustration and detach the clip and guide.
|
Place Hand Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Place your hand at the position shown in the illustration and pull in the removal direction (1).
Pull in the removal direction (2) shown in the illustration, detach the guide and remove the front seat outer leg cover LH.
71139Q
4.REMOVE FRONT SEAT INNER LEG COVER LH
Use the same procedure described for the outer side.
71140A
5.REMOVE FRONT SEAT LEG ASSEMBLY LH
| *A | w/ Seat Belt Warning System |
| *B | w/ Front Seat Side Airbag |
| *C | w/ Seat Position Airbag Sensor |
for Driver Side:
Detach the claw and clamp.
for Front Passenger Side:
| *A | w/ Seat Belt Warning System |
| *B | w/ Front Seat Side Airbag |
Detach the claw and clamp.
Remove the 3 clip.
Remove the 5 nuts and front seat leg assembly LH.
72495A
6.REMOVE FRONT SEAT VERTICAL ADJUSTER HANDLE LH (for Driver Side)
|
Lift in this Direction |
|
Remove in this Direction |
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw and remove the front seat vertical adjuster handle LH while lifting it up as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
72551L
7.REMOVE RECLINING HINGE COVER LH
|
Remove in this Direction |
Using moulding remover A, detach the claw and guide and remove the reclining hinge cover LH as shown in the illustration.
72526H
8.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
Detach the guide and remove the reclining adjuster release handle LH.
71849J
9.REMOVE FRONT SEAT NO. 3 ADJUSTER COVER CAP LH (for Driver Side)
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Using moulding remover A, detach the claw in the removal direction (1) shown in the illustration.
Pull in the removal direction (2) shown in the illustration, detach the guide and remove the front seat No. 3 adjuster cover cap LH.
71812T
10.REMOVE FRONT SEAT CUSHION SHIELD LH (for Driver Side)
|
Remove in this Direction |
Using moulding remover A, detach the claw and guide as shown in the illustration.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the position and pull in the removal direction shown in the illustration and detach the claw.
|
Remove in this Direction |
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the position and pull in the removal direction shown in the illustration and detach the guide and remove the front seat cushion shield LH.
71862K
11.REMOVE FRONT SEAT INNER CUSHION SHIELD LH (for Driver Side)
|
Remove in this Direction |
Using moulding remover A, detach the claw and guide as shown in the illustration.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the position and pull in the removal direction shown in the illustration and detach the claw.
|
Remove in this Direction |
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the position shown in the illustration and pull in the removal direction and detach the guide and remove the front seat inner cushion shield LH.
71861K
12.REMOVE FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)
|
Remove in this Direction |
Using moulding remover A, detach the claw and guide as shown in the illustration.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the position and pull in the removal direction shown in the illustration and detach the claw.
|
Remove in this Direction |
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the position and pull in the removal direction shown in the illustration and detach the guide and remove the front seat inner cushion shield RH.
71811T
13.REMOVE FRONT SEAT CUSHION SHIELD RH (for Front Passenger Side)
|
Remove in this Direction |
Using moulding remover A, detach the claw and guide as shown in the illustration.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the position and pull in the removal direction shown in the illustration and detach the claw.
|
Remove in this Direction |
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.
|
Place Hand Here |
|
Remove in this Direction |
Place your hand at the position and pull in the removal direction shown in the illustration and detach the guide and remove the front seat cushion shield RH.
73240
14.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)
w/o Sub Wire Harness:
Detach the clamp.
w/ Sub Wire Harness:
Disconnect the connector.
Detach the claw and clamp.
Remove the nut and front seat inner belt assembly LH.
Remove the front seat belt anchor plate.
73230
15.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)
w/ Seat Belt Warning System, w/o Front Seat Side Airbag:
Disconnect the connector.
Detach the clamp.
w/ Seat Belt Warning System, w/ Front Seat Side Airbag:
Disconnect the 2 connectors.
Detach the clamp and claw.
Remove the nut and front seat inner belt assembly RH.
Remove the front seat belt anchor plate.
71705G
16.REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Seatback Board)
Detach the band.
|
Remove in this Direction |
Remove the 2 screws.
Detach the hook and remove the front seatback board sub-assembly LH as shown in the illustration.
17.REMOVE FRONT SEATBACK ASSEMBLY
w/o Front Seatback Board:
Detach the band.
Detach the hook.
w/ Front Seat Side Airbag:
Disconnect the connector.
Detach the clamp and claw.
Remove the 4 bolts.
|
Protective Tape |
Using a screwdriver, detach the guide and remove the front seatback assembly.
Tape the screwdriver tip before use.
18.REMOVE FRONT SEATBACK COVER WITH PAD
w/ Front Seatback Board:
Pull out the 2 fasteners.
Detach the hook.
w/ Front seat side airbag.
Front seat side airbag harness through the hole of the seatback cover.
Open the 2 fasteners.
|
Remove in this Direction |
Detach the claw and remove the 2 front seat headrest supports as shown in the illustration.
Remove the front seatback cover with pad.
71074A
19.REMOVE FRONT SEATBACK COVER SUB-ASSEMBLY LH
w/ Front Seat Side Airbag:
Using a thin-bladed screwdriver, detach the hook and remove the front seatback cover sub-assembly LH from the front seatback pad LH as shown in the illustration.
| *A | except Wagon | *B | for Wagon |
|
Protective Tape | - | - |
Be careful not to damage the front seatback cover sub-assembly LH.
Tape the thin-bladed screwdriver tip before use.
w/o Front Seat Side Airbag:
Using a thin-bladed screwdriver, detach the hook and remove the front seatback cover sub-assembly LH from the front seatback pad LH as shown in the illustration.
| *A | for Type A | *B | for Type B |
| *C | for Wagon | - | - |
|
Protective Tape | - | - |
Be careful not to damage the front seatback cover sub-assembly LH.
Tape the thin-bladed screwdriver tip before use.
73920B
20.REMOVE FRONT SEAT AIRBAG ASSEMBLY LH (w/ Front Seat Side Airbag)
71053A
21.REMOVE FRONT SEATBACK SPRING SUB-ASSEMBLY LH
| *a | Clamp |
| *b | Guide |
|
Remove in this Direction |
Detach the clamp.
Detach the guide and remove the front seatback spring sub-assembly LH as shown in the illustration.
71587L
22.REMOVE FRONT SEATBACK EDGE PROTECTOR
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw and remove the 2 front seatback edge protectors.
Tape the thin-bladed screwdriver tip before use.
71759F
23.REMOVE FRONT SEATBACK HOOK
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw and remove the 2 front seatback hooks.
Do not reuse the removed front seatback hook.
Tape the thin-bladed screwdriver tip before use.
24.REMOVE SCREW GROMMET (w/ Seatback Board)
Remove the 2 screw grommets.
25.REMOVE FRONT SEAT CUSHION COVER WITH PAD
w/ Occupant Detection Sensor:
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw.
Tape the thin-bladed screwdriver tip before use.
Detach the hook.
Detach the hook and remove the front seat cushion cover with pad.
71072
26.REMOVE FRONT SEAT CUSHION COVER SUB-ASSEMBLY LH
| *a | Band |
|
Remove in this Direction |
Detach the band as shown in the illustration.
Using a thin-bladed screwdriver, detach the hook and remove the front seat cushion cover sub-assembly LH from the front seat cushion pad LH as shown in the illustration.
|
Protective Tape | - | - |
Be careful not to damage the front seat cushion cover sub-assembly LH.
Tape the thin-bladed screwdriver tip before use.
82F66
27.REMOVE CONNECTOR HOLDER (w/ Occupant Detection Sensor)
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw and remove the connector holder.
Tape the thin-bladed screwdriver tip before use.
71H76B
28.REMOVE LH SEAT RECLINING ADJUSTER INSIDE COVER LH
|
Remove in this Direction |
Detach the claw and hook and remove the LH seat reclining adjuster inside cover LH as shown in the illustration.
71H75C
29.REMOVE LH SEAT RECLINING ADJUSTER INSIDE COVER RH
|
Remove in this Direction |
Detach the claw and hook and remove the LH seat reclining adjuster inside cover RH as shown in the illustration.
71874V
30.REMOVE FRONT SEAT OUTER CUSHION SHIELD (for Driver Side)
| *a | Hook |
| *b | Guide |
|
Remove in this Direction |
|
Protective Tape |
Detach the hook.
Using a thin-bladed screwdriver, detach the claw.
Tape the thin-bladed screwdriver tip before use.
Detach the guide and remove the front seat outer cushion shield as shown in the illustration.
71874W
31.REMOVE FRONT SEAT INNER CUSHION SHIELD (for Driver Side)
| *a | Hook |
| *b | Guide |
|
Remove in this Direction |
|
Protective Tape |
Detach the hook.
Using a thin-bladed screwdriver, detach the claw.
Tape the thin-bladed screwdriver tip before use.
Detach the guide and remove the front seat inner cushion shield as shown in the illustration.
7181BA
32.REMOVE FRONT SEAT CUSHION WIRE HARNESS HOLDER LH
Remove the front seat wire together with the front seat cushion wire harness holder LH.
w/ Seat Position Airbag Sensor:
Disconnect the connector.
Detach the clamp.
Remove the 2 screws.
Detach the guide and remove the front seat cushion wire harness holder LH.
8219A
33.REMOVE FRONT SEAT NO. 2 WIRE RH (for Driver Side, w/ Seat Position Airbag Sensor)
Disconnect the connector.
Detach the clamp and claw and remove the front seat No. 2 wire RH.
82192
34.REMOVE FRONT SEAT WIRE LH (for Driver Side, w/ Sub Wire Harness)
Detach the clamp and remove the front seat wire LH.
82191
35.REMOVE FRONT SEAT WIRE RH (for Front Passenger Side, w/ Front Seat Side Airbag)
Detach the clamp and remove the front seat wire RH.
72211G
36.REMOVE SEAT TRACK ADJUSTING HANDLE LH
|
Remove in this Direction |
Using a thin-bladed screwdriver, detach the claw and remove the seat track adjusting handle LH as shown in the illustration.
Tape the thin-bladed screwdriver tip before use.