Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TELEVISION CAMERA (for Side) › from 2019.06
RM35X0E _56 Audio / Visual / Telematics _079315 PARK ASSIST / MONITORING _0398773 TELEVISION CAMERA(for Side) A

PARK ASSIST / MONITORING  TELEVISION CAMERA(for Side)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the side television camera assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement part or procedure Necessary procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
·

Side television camera assembly LH (Including removal and installation)

·

Side television camera assembly RH (Including removal and installation)


Side television camera view adjustment Panoramic view monitor system (Click here)
·

Front television camera assembly, radiator grille assembly or front bumper assembly

·

Television camera assembly

·

Side television camera assembly LH or outer rear view mirror assembly LH

·

Side television camera assembly RH or outer rear view mirror assembly RH


Television camera view adjustment (Adjustment of all cameras)
HINT:

Replacement or removal and installation of 2 or more parts


Panoramic view monitor system (Click here)

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 87945 2.REMOVE OUTER MIRROR COVER LH

Hide 81740 3.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH

Hide 86790F 4.REMOVE SIDE TELEVISION CAMERA ASSEMBLY LH

a.
B552035

Detach the wire harness clamp.


b.

Remove the 2 screws and side television camera assembly LH.