w/ Panoramic view monitor system:
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during side turn signal light assembly removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
87961
1.REMOVE OUTER MIRROR LH
87945
2.REMOVE OUTER MIRROR COVER LH
81740
3.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH
Remove the cover body.
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>DISASSEMBLY
|
Remove in this Direction |
Detach the claw to remove the side turn signal light assembly LH.
Disconnect the connector.