The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel main valve assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
1. PRECAUTION
After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
77020A
3.REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
23217D
4.REMOVE FUEL PUMP FILTER
23070
5.REMOVE FUEL MAIN VALVE ASSEMBLY
Remove the fuel main valve assembly (for High Pressure).
Remove the clip from the fuel suction plate sub-assembly (fuel filter).
Do not damage the fuel suction plate sub-assembly (fuel filter).
Remove the fuel main valve assembly (for High Pressure) from the fuel suction plate sub-assembly (fuel filter).
Do not damage the fuel suction plate sub-assembly (fuel filter).
| *1 | O-ring |
Remove the 2 O-rings from the fuel main valve assembly (for High Pressure).
Remove the fuel main valve assembly (for Low Pressure).
Remove the clip from the fuel suction plate sub-assembly (fuel filter).
Do not damage the fuel suction plate sub-assembly (fuel filter).
Remove the fuel main valve assembly (for Low Pressure) from the fuel suction plate sub-assembly (fuel filter).
Do not damage the fuel suction plate sub-assembly (fuel filter).
| *1 | O-ring |
Remove the 2 O-rings from the fuel main valve assembly (for Low Pressure).