Home › Engine / Hybrid System › 1GD-FTV (EMISSION CONTROL) › UREA PUMP CONTROL ECU › from 2019.06
RM35X0E _51 Engine / Hybrid System _079220 1GD-FTV EMISSION CONTROL _0384129 UREA PUMP CONTROL ECU A

1GD-FTV EMISSION CONTROL  UREA PUMP CONTROL ECU  INSTALLATION  


PROCEDURE

Hide 896B1 1.INSTALL UREA PUMP CONTROL ECU

a.

Install the urea pump control ECU to the No. 1 urea pump control bracket with the 3 bolts.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


b.

Install the No. 1 urea pump control bracket to the body with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.
A440856C01
0,0 0,0 false
V113147

Move in this Direction


Connect the connector to the urea pump control ECU, and then move the lever in the direction indicated by the arrow shown in the illustration to lock the connector.

NOTICE:

When connecting a connector, make sure that dirt, water and other foreign matter is not stuck between the connector and urea pump control ECU.



Hide 89678B 2.INSTALL NO. 2 UREA PUMP CONTROL BRACKET (w/o Stop And Start System)

a.

Attach the 2 clips and install the No. 2 urea pump control bracket to the No. 1 urea pump control bracket.


Hide G92C0B 3.INSTALL ECO RUN VEHICLE CONVERTER ASSEMBLY (w/ Stop And Start System)