Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › ECD SYSTEM (for Water Cooled Type Intercooler) › from 2020.05
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0412266 ECD SYSTEM(for Water Cooled Type Intercooler) Y

1GD-FTV ENGINE CONTROL  ECD SYSTEM(for Water Cooled Type Intercooler)  BASIC INSPECTION  


CAUTION / NOTICE / HINT

HINT:

When a malfunction cannot be confirmed by the DTC check, troubleshooting should be performed on all circuits that are possible causes of the problem. However, in most cases, performing the basic engine check shown below can help you find the problem quickly and efficiently. Always perform this check first when troubleshooting the engine.


PROCEDURE

1.CHECK BATTERY VOLTAGE
NOTICE:

Perform the battery voltage check with the engine stopped and the ignition switch off.


Result:
Result Proceed to
11 V or higher OK
Below 11 V NG



OK

2.CHECK IF ENGINE WILL CRANK

NG

CHARGE OR REPLACE BATTERY

2.CHECK IF ENGINE WILL CRANK
Result:
Proceed to
OK
NG



OK

3.CHECK AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

NG

PROCEED TO PROBLEM SYMPTOMS TABLE

3.CHECK AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
a.

Visually check that the air cleaner filter element sub-assembly is not excessively contaminated with dirt or oil.


Result:
Proceed to
OK
NG



OK

4.REPLACE FUEL

NG

CLEAN OR REPLACE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

4.REPLACE FUEL
a.

Check that only diesel fuel is being used.


b.

Check that the fuel does not contain any impurities.


Result:
Proceed to
OK
NG



OK

5.CHECK FUEL FOR AIR

NG

REPLACE FUEL

5.CHECK FUEL FOR AIR
Result:
Proceed to
OK
NG



OK

6.CHECK FUEL PIPES AND HOSES

NG

BLEED AIR FROM FUEL

6.CHECK FUEL PIPES AND HOSES
a.

Check that the fuel pipes and fuel hoses are not blocked, damaged, disconnected or bent.


Result:
Proceed to
OK
NG



OK

7.CHECK FUEL FILTER ELEMENT ASSEMBLY FOR BLOCKAGE

NG

REPAIR OR REPLACE FUEL PIPES OR HOSES

7.CHECK FUEL FILTER ELEMENT ASSEMBLY FOR BLOCKAGE
Result:
Proceed to
OK
NG



OK

8.CHECK ENGINE OIL

NG

CLEAN OR REPLACE FUEL FILTER ELEMENT ASSEMBLY

8.CHECK ENGINE OIL
Result:
Proceed to
OK
NG



OK

9.CHECK ENGINE COOLANT

NG

ADD OR REPLACE ENGINE OIL

9.CHECK ENGINE COOLANT
Result:
Proceed to
OK
NG



OK

10.CHECK IDLING SPEED AND MAXIMUM SPEED

NG

ADD OR REPLACE ENGINE COOLANT

10.CHECK IDLING SPEED AND MAXIMUM SPEED
HINT:

If the result is not as specified, perform troubleshooting according to the symptoms table.


Result:
Proceed to
NEXT



NEXT

11.CHECK DIAGNOSTIC CIRCUIT
11.CHECK DIAGNOSTIC CIRCUIT
Result:
Proceed to
OK
NG



OK

12.CHECK VACUUM PUMP ASSEMBLY

NG

REPAIR OR REPLACE MALFUNCTIONING CIRCUIT

12.CHECK VACUUM PUMP ASSEMBLY
Result:
Proceed to
OK
NG



OK

PROCEED TO PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE VACUUM PUMP