The ECM sends and receives data to and from the urea pump control ECU via local CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| U010E87 | Lost Communication with Reductant Control Module Missing Message | Communication stops between the ECM and the urea pump control ECU for 1.6 second or more (1 trip detection logic). | ·
Urea pump control ECU ·
Harness or connector ·
DCU MAIN relay ·
ECM |
Comes on | DTC stored | SAE Code: U010E |
The ECM stores a DTC when a communication malfunction occurs between the ECM and urea pump control ECU.
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| U010E87 | 1.6 seconds or more after turning the ignition switch to ON. |
Inspect the fuses of circuits related to this system before performing the following inspection procedure.
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
According to the display on the GTS, select "Health Check".
Check for currently output system DTCs.
| Result | Proceed to |
|---|---|
| DTC U010E87 is output | A |
| DTC U010E87 and other DTCs are output* | B |
*: If any other DTCs are output, perform troubleshooting for those DTCs first.
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B