78110K
1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY (for Air Cooled Type Intercooler)
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / Accelerator Sensor No.1 Voltage % and Accelerator Sensor No.2 Voltage %.
| Tester Display |
|---|
| Accelerator Position Sensor No.1 Voltage % |
| Accelerator Position Sensor No.2 Voltage % |
Operate the accelerator pedal sensor assembly and check that the "Accelerator Sensor No.1 Voltage %" and "Accelerator Sensor No.2 Voltage %" values are within the specification.
| Accelerator Pedal Condition | Specified Condition |
|---|---|
| Released | 10 to 22% |
| Depressed | 52 to 90% |
| Accelerator Pedal Condition | Specified Condition |
|---|---|
| Released | 24 to 40% |
| Depressed | 68 to 99% |
If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.
78110K
2.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY (for Water Cooled Type Intercooler)
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / Accelerator Sensor No.1 Voltage % and Accelerator Sensor No.2 Voltage %.
| Tester Display |
|---|
| Accelerator Position Sensor No.1 Voltage % |
| Accelerator Position Sensor No.2 Voltage % |
Operate the accelerator pedal sensor assembly and check that the "Accelerator Position Sensor No.1 Voltage %" and "Accelerator Position Sensor No.2 Voltage %" values are within the specification.
| Accelerator Pedal Condition | Specified Condition |
|---|---|
| Released | 10 to 22% |
| Depressed | 52 to 90% |
| Accelerator Pedal Condition | Specified Condition |
|---|---|
| Released | 24 to 40% |
| Depressed | 68 to 99% |
If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.