Home › Engine / Hybrid System › 1GD-FTV (INTAKE / EXHAUST) › RADIATOR (for Water Cooled Type Intercooler) › from 2020.05
RM35X0E _51 Engine / Hybrid System _079307 1GD-FTV INTAKE / EXHAUST _0415318 RADIATOR(for Water Cooled Type Intercooler) G

1GD-FTV INTAKE / EXHAUST  RADIATOR(for Water Cooled Type Intercooler)  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:

Do not remove the reserve tank cap (for Intercooler) while the engine and intercooler cooling radiator assembly are still hot. Pressurized, hot engine coolant (for Intercooler) and steam may be released and cause serious burns.


PROCEDURE

Hide 16475D 1.INSPECT RESERVE TANK CAP (for Intercooler)

a.

Measure the valve opening pressure.

i.
A287226C13
0.677,1.948 0.844,1.948 0.844,1.948 1.229,1.708 false 2.844,1.802 2.656,1.802 2.656,1.802 2.052,1.458 true 0.427,1.854 0.667,2.021 0.24,0.167 10 false *a 2.906,1.729 3.135,1.906 0.229,0.177 10 false *b
*a O-ring
*b Rubber Packing


If there are water stains or foreign matter on the O-ring, clean it with water and finger scouring.

NOTICE:

Always perform procedure by hand so as not to damage the O-ring.



ii.

Check that the O-ring is not deformed, cracked or swollen.


iii.

Apply engine coolant to the O-ring and rubber packing before using a radiator cap tester.


iv.
B008802C21
0.479,0.563 0.667,0.198 0.667,0.198 0.833,0.198 false 1.021,0.708 1.365,0.198 1.365,0.198 1.531,0.198 false 0.885,0.083 1.198,0.24 0.313,0.156 10 false *1 1.594,0.083 1.906,0.24 0.313,0.156 10 false *a 0.531,1.052 0.844,1.208 0.313,0.156 10 false *b
*1 Reserve Tank Cap (for Intercooler)
*a Radiator Cap Tester
*b 30° or more


When using the radiator cap tester, tilt it more than 30° degrees.


v.

Pump the radiator cap tester several times and check the maximum pressure*.

Pump speed:

1 pump per second


*: Even if the cap cannot maintain the maximum pressure, it is not a defect.

Standard Judgment Criterion:
Item Specified Condition
Standard value (for brand-new cap) 93 to 123 kPa (1.0 to 1.3 kgf/cm2, 13.5 to 18 psi)
Minimum standard value (for used cap) 79 kPa (0.8 kgf/cm2, 11.4 psi)


If the maximum pressure is less than the minimum standard value, replace the reserve tank cap (for Intercooler).