Home › Engine / Hybrid System › 1GD-FTV (ENGINE CONTROL) › INTAKE AIR TEMPERATURE SENSOR › from 2020.05
RM35X0E _51 Engine / Hybrid System _078856 1GD-FTV ENGINE CONTROL _0387396 INTAKE AIR TEMPERATURE SENSOR G

1GD-FTV ENGINE CONTROL  INTAKE AIR TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 89424A 1.INSPECT INTAKE AIR TEMPERATURE SENSOR (for Air Cooled Type Intercooler)

a.

Partially immerse the intake air temperature sensor in water and warm up the water.


b.
A459796C01
1.083,0.094 1.396,0.292 0.313,0.198 10 false *a
*a Component without harness connected (Intake Air Temperature Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 2.21 to 2.65 kΩ
60 °C (140 °F) 0.54 to 0.62 kΩ


CAUTION:
·

Do not put your hands in the water warmed up during the inspection.

·

Touching the hot water may result in burns.



NOTICE:

When checking the intake air temperature sensor in water, do not allow water to contact the terminals. After completing the check, dry the intake air temperature sensor.


If the result is not as specified, replace the intake air temperature sensor.


Hide 89424A 2.INSPECT INTAKE AIR TEMPERATURE SENSOR (for Water Cooled Type Intercooler)

a.

Partially immerse the intake air temperature sensor in water and warm up the water.


b.
A459796C01
1.083,0.094 1.396,0.292 0.313,0.198 10 false *a
*a Component without harness connected (Intake Air Temperature Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 25°C (77°F) 15.94 to 18.53 kΩ
50 °C (122 °F) 9.01 to 10.25 kΩ


CAUTION:
·

Do not put your hands in the water warmed up during the inspection.

·

Touching the hot water may result in burns.



NOTICE:

When checking the intake air temperature sensor in water, do not allow water to contact the terminals. After completing the check, dry the intake air temperature sensor.


If the result is not as specified, replace the intake air temperature sensor.