Home › Audio / Visual / Telematics › TELEMATICS › MAYDAY BATTERY › from 2021.07
RM35X0E _56 Audio / Visual / Telematics _078380 TELEMATICS _0380047 MAYDAY BATTERY A

TELEMATICS  MAYDAY BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the mobilephone battery removal/installation are shown below.

Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Telematics transceiver
for ERA-GLONASS:

Register vehicle information


Emergency call service (Click here)
for Toyota Connected Services:

Register vehicle information


Telematics system (Click here)
Mobilephone battery
for ERA-GLONASS:

Reset mobilephone battery condition


Emergency call service (Click here)
for Toyota Connected Services:

Reset mobilephone battery condition


(Click here)

PROCEDURE

Hide 86742 3.REMOVE TRANSCEIVER COVER

a.
E441498

Detach the claw and remove the transceiver cover.


Hide 86725 4.REMOVE MOBILEPHONE BATTERY

a.
E441499

Disconnect the connector and remove the mobilephone battery.